The main business of the company is: bladder accumulator, Diaphragm accumulator, Piston Type Accumulator, oxygen cylinder, CO2 cylinder, gas cylinder, nitrogen gas cylinder, Welcome to inquire and negotiate cooperation by phone.
About    |    Contact

News

The connection method of the accumulator

The connection method of an accumulator, typically referred to as a battery in everyday terminology, can vary based on the specific requirements of the application. Here are some common connection methods:

  1. Series Connection: In a series connection, the positive terminal of one battery is connected to the negative terminal of another battery. This increases the total voltage of the system while keeping the capacity constant. For example, if you connect two 12-volt batteries in series, you get a total voltage of 24 volts.
  2. Parallel Connection: In a parallel connection, the positive terminals of all accumulator are connected together, and the negative terminals are connected together. This increases the total capacity of the system while keeping the voltage constant. For example, if you connect two 12-volt batteries in parallel, you still have a total voltage of 12 volts, but the capacity (ampere-hours) doubles.
  3. Series-Parallel Connection: This method combines both series and parallel connections to achieve both increased voltage and capacity. Batteries are grouped in series, and then these series groups are connected in parallel. This method allows for greater flexibility in meeting the voltage and capacity requirements of a system.
  4. Distributed Connection: In some cases, batteries may be distributed throughout a system, with each battery serving a specific load or subsystem. This approach can provide redundancy and improve system reliability, especially in critical applications.

The choice of connection method depends on factors such as the required voltage, capacity, available space, and desired balance between redundancy and efficiency. It’s important to carefully consider these factors when designing or configuring a accumulator system for a particular application.

Prev:

Next:

Leave a Reply